81
Parameter
linenum —— The number of users allowed to login through console port. Its
value is 0 in general, for the reason that console input is only active on one
console port at a time.
startlinenum ——The start serial number of the login user selected to configure
the login mode and password, ranging from 0 to 15. 0 means the first login user
number, 1 means the second, and the rest can be done on the same manner.
endlinenum —— The end serial number of the login user selected to configure
the login mode and password, ranging from 0 to 15. 0 means the first login user
number, 1 means the second, and the rest can be done on the same manner.
ssh —— Configure the SSH terminal line.
telnet —— Configure the Telnet terminal line.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enter the Console port configuration mode and configure the console port 0:
T2600G-28TS(config)#line console 0
Enter the Virtual Terminal configuration mode so as to prepare further
configurations such as password and login mode for virtual terminal 0 to 5:
T2600G-28TS(config)#line vty 0 5
12.8 password
Description
The password command is used to configure the connection password. To
clear the password, please use no password command.
Syntax
password { [ 0 ] password | 7 encrypted-password }
no password
To Next Page
Loading...
