TP-Link T2600G-28TS - Access-List Bind(Interface); Access-List Bind(Vlan)

258
33.21 access-list bind(interface)
Description
The access-list bind command is used to bind a policy to a specified port. To
cancel the bind relation, please use no access-list bind command.
Syntax
access-list bind policy-name
no access-list bind policy-name
Parameter
policy-name —— The name of the policy desired to bind.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Bind policy1 to port 1/0/2:
T2600G-28TS(config)# interface gigabitEthernet 1/0/2
T2600G-28TS(config-if)# access-list bind policy1
33.22 access-list bind(vlan)
Description
The access-list bind command is used to bind a policy to a VLAN. To cancel
the bind relation, please use no access-list bind command.
Syntax
access-list bind policy-name
no access-list bind policy-name
Parameter
policy-name —— The name of the policy desired to bind.
Command Mode
Interface VLAN Mode