TP-Link T2600G-28TS - Shutdown; Interface Port-Channel

380
T2600G-28TS(config)# interface gigabitEthernet 1/0/9
T2600G-28TS(config-if)# no switchport
T2600G-28TS(config-if)# description system-if
42.6 shutdown
Description
This shutdown command is used to shut down the specified interface. The
interface type include: routed port, port-channel interface, loopback interface
and VLAN interface. To enable the specified interface, please use the no
shutdown command.
Syntax
shutdown
no shutdown
Command Mode
Interface Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Shut down the routed port 1/0/9 :
T2600G-28TS(config)# interface gigabitEthernet 1/0/9
T2600G-28TS(config-if)# no switchport
T2600G-28TS(config-if)# shutdown
42.7 interface port-channel
Description
This interface port-channel command is used to create the port-channel
interface. To delete the specified port-channel interface, please use the no
interface port-channel command.
Syntax
interface port-channel { port-channel-id }
no interface port-channel { port-channel-id }