TP-Link T2600G-28TS - Lldp Med-Fast-Count; Lldp Med-Status

366
40.8 lldp med-fast-count
Description
The lldp med-fast-count command is used to configure the number of the
LLDP-MED frames that will be sent out. When LLDP-MED fast start mechanism
is activated, multiple LLDP-MED frames will be transmitted based on this
parameter. The default value is 4. To return to the default configuration, please
use no lldp med-fast-count command.
Syntax
lldp med-fast-count count
no lldp med-fast-count
Parameter
count —— Configure the Fast Start Count parameter. It ranges from 1 to 10. By
default, it is 4.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify Fast Start Count as 5:
T2600G-28TS(config)# lldp med-fast-count 5
40.9 lldp med-status
Description
The lldp med-status command is used to enable the LLDP-MED feature for the
corresponding port. After the LLDP-MED feature is enabled, the port's Admin
Status will be changed to Tx&Rx. To disable the LLDP-MED feature for the
corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)