TP-Link T2600G-28TS - Ip Igmp Snooping Rtime

298
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable IGMP Snooping function of port 1/0/3:
T2600G-28TS(config)# interface gigabitEthernet 1/0/3
T2600G-28TS(config-if)# ip igmp snooping
37.3 ip igmp snooping rtime
Description
The ip igmp snooping rtime command is used to specify router port aging time
globally. To restore the default timer, please use no ip igmp snooping rtime
command.
Syntax
ip igmp snooping rtime rtime
no ip igmp snooping rtime
Parameter
rtime —— Specify the aging time in seconds, ranging from 60 to 600. The
default aging time is 300 seconds.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify IGMP Snooping router port aging time as 100 seconds globally:
T2600G-28TS(config)# ip igmp snooping rtime 100