TP-Link T2600G-28TS - Media-Type Rj45

84
Example
Configure the login of virtual terminal connection 0-5 as login local mode:
T2600G-28TS(config)#line vty 0 5
T2600G-28TS(config-line)#login local
Configure the login of Console port connection 0 as login local mode:
T2600G-28TS(config)#line console 0
T2600G-28TS(config-line)#login local
12.11 media-type rj45
Description
The media-type rj45 command is used to configure the console media type as
RJ-45 for input. The switch has two console ports available —— an RJ-45
console port and a micro-USB console port. Console input is active on only one
console port at a time. By default, the micro-USB connector takes precedence
over the RJ-45 connector, which means that, when both the RJ-45 console
connection and micro-USB console connection are valid, input from the RJ-45
console is disabled, and input from the micro-USB console is enabled. To return
to the default configuration, please use no media-type rj45 command.
Syntax
media-type rj45
no media-type rj45
Command Mode
Line Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enable the RJ-45 console input:
T2600G-28TS(config)# line console 0
T2600G-28TS(config-line)# media-type rj45
Receive the micro-USB console input prior to the RJ-45 console input:
T2600G-28TS(config)# line console 0
T2600G-28TS(config-line)# no media-type rj45