56
T2600G-28TS(config-if)# l2protocol-tunnel type uni stp threshold 1000
8.3 show l2protocol-tunnel global
Description
The show l2protocol-tunnel global command is used to display the global
L2PT status.
Syntax
show l2protocol-tunnel global
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the global L2PT status:
T2600G-28TS(config)# show l2protocol-tunnel global
8.4 show l2protocol-tunnel interface
Description
The show l2protocol-tunnel interface command is used to display the L2PT
configuration information of a specified Ethernet port or of all Ethernet ports.
Syntax
show l2protocol-tunnel interface [ gigabitEthernet port | port-channel
port-channel-id ]
Parameter
port —— The port number.
port-channel-id —— The ID of the port channel.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
To Next Page
Loading...
