TP-Link T2600G-28TS - Ipv6 Mld Snooping Drop-Unknown; Ipv6 Mld Snooping Last-Listener Query-Inteval

323
Syntax
ipv6 mld snooping immediate-leave
no ipv6 mld snooping immediate-leave
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable the Fast Leave function for port 1/0/3:
T2600G-28TS(config)# interface gigabitEthernet 1/0/3
T2600G-28TS(config-if)# ipv6 mld snooping immediate-leave
38.7 ipv6 mld snooping drop-unknown
Description
The ipv6 mld snooping drop-unknown command is used to enable the
unknown multicast packets filter function. To disable this function, please use no
ipv6 mld snooping drop-unknown command. By default, it is disabled.
Syntax
ipv6 mld snooping drop-unknown
no ipv6 mld snooping drop-unknown
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable unknown multicast filter function:
T2600G-28TS(config)# ipv6 mld snooping drop-unknown
38.8 ipv6 mld snooping last-listener query-inteval
Description
The ipv6 mld snooping last-listener query-inteval command is used to
specify the interval to send Specific Query Message. The default value is 1
second. To restore the default interval, please use no ipv6 mld snooping
last-listener query-inteval command.