TP-Link T2600G-28TS - Ip Route

381
Parameter
port-channel-id —— The ID of the port-channel interface, ranging from 1 to 14.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Create the port-channel interface 1:
T2600G-28TS(config)# interface port-channel 1
42.8 ip route
Description
This ip route command is configure the static route. To clear the corresponding
entry, please use the no ip route command.
Syntax
ip route { dest-address } { mask } { next-hop-address } [ distance ]
no ip route { dest-address } { mask } { next-hop-address }
Parameter
dest-address —— The destination IP address.
mask —— The subnet mask.
next-hop-address —— The address of the next-hop.
distance —— The distance metric of this route, ranging from 1 to 255. The
smaller the distance is, the higher the priority is.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Create a static route with the destination IP address as 192.168.2.0, the subnet
mask as 255.255.255.0 and the next-hop address as 192.168.0.2: