TP-Link T2600G-28TS - 6.8 GVRP

78
Syntax
service password-recovery
no service password-recovery
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enable the switch’s password recovery feature:
T2600G-28TS(config)# service password-recovery
12.4 user access-control ip-based
Description
The user access-control ip-based command is used to limit the IP-range of
the users for login. Only the users within the IP-range you set here are allowed
to login. To cancel the user access limit, please use no user access-control
command.
Syntax
user access-control ip-based { ip-addr ip-mask } [ snmp ] [ telnet ] [ ssh ] [ http ]
[ https ] [ ping ] [ all ]
no user access-control [ ip-based index id ]
Parameter
ip-addr —— The source IP address. Only the users within the IP-range you set
here are allowed for login. 5 IP-based entries can be configured at most.
ip-mask —— The subnet mask of the IP address.
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] —— Specify the access
interface. These interfaces are enabled by default.
id —— Delete the specified IP-based entry. The index ranges from 1 to 5.
Command Mode
Global Configuration Mode