TP-Link T2600G-28TS - 8.3 RFI

117
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the Gigabit Ethernet port 1/0/2 to be a Trusted Port:
T2600G-28TS(config)#interface gigabitEthernet 1/0/2
T2600G-28TS(config-if)#ipv6 dhcp snooping trust
16.5 ipv6 nd snooping
Description
The ipv6 nd snooping command is used to enable ND Snooping function
globally. To disable ND Snooping function globally, please use no ipv6 nd
snooping command. ND Snooping functions to monitor the process of the
duplication address detection, And record the IPv6 address, MAC address,
VLAN and the connected Port number of the Host for automatic binding.
Syntax
ipv6 nd snooping
no ipv6 nd snooping
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the ND Snooping function globally:
T2600G-28TS(config)#ipv6 nd snooping