TP-Link T2600G-28TS - Ethernet-Oam Remote-Loopback; Clear Ethernet-Oam Statistics

287
T2600G-28TS(config)# interface gigabitEthernet 1/0/1
T2600G-28TS(config-if)# ethernet-oam remote-loopback received
-remote-loopback process
35.9 ethernet-oam remote-loopback
Description
The ethernet-oam remote-loopback command is used to request the remote
peer to start or stop the Ethernet OAM remote loopback mode.
Syntax
ethernet-oam remote-loopback { start | stop }
Parameter
start —— Request the remote peer to start the Ethernet OAM remote loopback
mode.
stop —— Request the remote peer to stop the Ethernet OAM remote loopback
mode.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Request the remote peer to start the Ethernet OAM remote loopback mode on
Gigabit Ethernet port 1/0/3:
T2600G-28TS(config)# interface gigabitEthernet 1/0/3
T2600G-28TS(config-if)# ethernet-oam remote-loopback start
35.10 clear ethernet-oam statistics
Description
The clear ethernet-oam statistics command is used to clear Ethernet OAM
statistics.