TP-Link T2600G-28TS - Show Mac Address-Table Count; Show Mac Address-Table Address

178
Privilege Requirement
None.
Example
Display the address configuration of port 1/0/1:
T2600G-28TS(config)# show mac address-table interface gigabitEthernet
1/0/1
25.13 show mac address-table count
Description
The show mac address-table count command is used to display the total
amount of MAC address table.
Syntax
show mac address-table count [ vlan vlan-id ]
Parameter
vlan-id —— Specify the VLAN which the MAC entries belong to.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the total MAC entry information in different VLANs:
T2600G-28TS(config)# show mac address-table count
25.14 show mac address-table address
Description
The show mac address-table address command is used to display the
information of the specified MAC address.
Syntax
show mac address-table address mac-addr [ interface { gigabitEthernet
port | port-channel port-channel-id } | vid vlan-id ]
Parameter
mac-addr ——The specified MAC address.