TP-Link T2600G-28TS - Ipv6 Mld Snooping Multi-Vlan-Config

327
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Forbid the Ethernet ports 1/0/1-3 as being router ports in VLAN 1 :
T2600G-28TS(config)# ipv6 mld snooping vlan-config 1 router-port-forbidd
interface gigabitEthernet 1/0/1-3
38.12 ipv6 mld snooping multi-vlan-config
Description
The ipv6 mld snooping multi-vlan-config command is used to create
Multicast VLAN. To delete the corresponding Multicast VLAN, please use no
ipv6 mld snooping multi-vlan-config command. To restore the default values,
please use no ipv6 mld snooping multi-vlan-config with specified
parameters.
Syntax
ipv6 mld snooping multi-vlan-config [ vlan-id ] [ rtime router-time | mtime
member-time | rport interface { gigabitEthernet port-list | port-channel
port-channel-id } ]
no ipv6 mld snooping multi-vlan-config [ rtime router-time | mtime
member-time | rport interface { gigabitEthernet port-list | port-channel
port-channel-id } ]
Parameter
vlan-id —— The ID of the multicast VLAN desired to create or modify, ranging
from 2 to 4094. If not specified, the default multicast VLAN will be selected.
router-time —— Router Port Time. Within this time, if the switch does not
receive IGMP query message from the router port, it will consider this port is not
a router port any more. Router Port Time ranges from 60 to 600 in seconds. By
default, it is 0 and the global router-time will be used.
member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global member-time will be used.
port-list —— The list of Ethernet ports.
port-channel-id —— The ID of the port channels.