TP-Link T2600G-28TS - Port-Channel Load-Balance

70
T2600G-28TS(config)# interface range gigabitEthernet 1/0/2-4
T2600G-28TS(config-if-range)# channel-group 1 mode on
11.2 port-channel load-balance
Description
The port-channel load-balance command is used to configure the Aggregate
Arithmetic for LAG. To return to the default configurations, please use no
port-channel load-balance command.
Syntax
port-channel load-balance { src-mac | dst-mac | src-dst-mac | src-ip | dst-ip |
src-dst-ip }
no port-channel load-balance
Parameter
src-mac —— The source MAC address. When this option is selected, the
Aggregate Arithmetic will be based on the source MAC address of the packets.
dst-mac —— The destination MAC address. When this option is selected, the
Aggregate Arithmetic will be based on the destination MAC address of the
packets.
src-dst-mac —— The source and destination MAC address. When this option is
selected, the Aggregate Arithmetic will be based on the source and destination
MAC addresses of the packets. The Aggregate Arithmetic for LAG is
“src-dst-mac” by default.
src-ip —— The source IP address. When this option is selected, the Aggregate
Arithmetic will be based on the source IP address of the packets.
dst-ip —— The destination IP address. When this option is selected, the
Aggregate Arithmetic will be based on the destination IP address of the packets.
src-dst-ip —— The source and destination IP address. When this option is
selected, the Aggregate Arithmetic will be based on the source and destination
IP addresses of the packets.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.