TP-Link T2600G-28TS - 9.3 Multicast Table

151
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the remote-ID as “mac” for the Gigabit Ethernet port 1/0/1:
T2600G-28TS (config)# interface gigabitEthernet 1/0/1
T2600G-28TS (config-if)# pppoe remote-id mac
22.5 show pppoe id-insertion global
Description
The show pppoe id-insertion global command is used to display the global
configuration of PPPoE Circuit-ID Insertion function.
Syntax
show pppoe id-insertion global
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the configuration of PPPoE Circuit-ID Insertion function globally:
T2600G-28TS # show pppoe circuit-id global
22.6 show pppoe id-insertion interface
Description
The show pppoe id-insertion interface command is used to display all ports’
or the specified port’s configuration information of PPPoE Circuit-ID Insertion
function.
Syntax
show pppoe id-insertion interface [gigabitEthernet port ]
Parameter
port —— The Fast/Gigabit Ethernet port number.