TP-Link T2600G-28TS - Chapter 15 LLDP

291
35.15 show ethernet-oam status
Description
The show ethernet-oam status command is used to display the Ethernet OAM
status of both the local and the remote client.
Syntax
show ethernet-oam status [ interface gigabitEthernet port ]
Parameter
port —— The Gigabit Ethernet port number. By default, the Ethernet OAM
status of all ports is displayed.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Display Ethernet OAM status of Gigabit Ethernet port 1/0/2:
T2600G-28TS(config)# show ethernet-oam status interface gigabitEthernet
1/0/2