TP-Link T2600G-28TS - Show Ethernet-Oam Configuration; Show Ethernet-Oam Event-Log

289
T2600G-28TS(config)# clear ethernet-oam event-log interface
gigabitEthernet 1/0/3
35.12 show ethernet-oam configuration
Description
The show ethernet-oam configuration command is used to display Ethernet
OAM configuration information.
Syntax
show ethernet-oam configuration [ interface gigabitEthernet port ]
Parameter
port —— The Gigabit Ethernet port number. By default, the Ethernet OAM
configuration information of all ports is displayed.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Display Ethernet OAM configuration information of Gigabit Ethernet port 1/0/2:
T2600G-28TS(config)# show ethernet-oam configuration interface
gigabitEthernet 1/0/2
35.13 show ethernet-oam event-log
Description
The show ethernet-oam event-log command is used to display the Ethernet
OAM event log.
Syntax
show ethernet-oam event-log [ interface gigabitEthernet port ]