TP-Link T2600G-28TS - Dot1 X Timeout

141
no dot1x quiet-period
Parameter
time —— The length of the quiet-period time. If one user’s authentication fails,
its subsequent IEEE 802.1x authentication requests will not be processed
during the quiet-period time. It ranges from 1 to 999 seconds and the default
value is 10 seconds.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the quiet-period function:
T2600G-28TS(config)#dot1x quiet-period
Enable the quiet-period function and set the quiet-period as 5 seconds:
T2600G-28TS(config)#dot1x quiet-period 5
21.7 dot1x timeout
Description
The dot1x timeout command is used to configure the server timeout and the
supplicant timeout. To restore to the default, please use no dot1x timeout
command.
Syntax
dot1x timeout { server-timeout time | supplicant-timeout time }
no dot1x timeout { server-timeout | supplicant-timeout }
Parameter
server-timeout time ——The maximum time for the switch to wait for the
response before resending a request to the server, ranging from 1 to 9 in
second. By default, it is 3 seconds.
supplicant-timeout time ——The maximum time for the switch to wait for the
response from supplicant before resending a request to the supplicant., ranging
from 1 to 9 in second. By default, it is 3 seconds.