TP-Link T2600G-28TS - Dot1 X Port-Control

144
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the Guest VLAN function for Gigabit Ethernet port 1/0/2:
T2600G-28TS(config)#interface gigabitEthernet 1/0/2
T2600G-28TS(config-if)#dot1x guest-vlan
21.11 dot1x port-control
Description
The dot1x port-control command is used to configure the Control Mode of
IEEE 802.1X for the specified port. By default, the control mode is “auto”. To
restore to the default configuration, please use no dot1x port-control
command.
Syntax
dot1x port-control {auto | authorized-force | unauthorized-force}
no dot1x port-control
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the port.
auto:
In this mode, the port will normally work only after passing the 802.1X
Authentication.
authorized-force: In this mode, the port can work normally without passing the
802.1X Authentication.
unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the Control Mode for Gigabit Ethernet port 20 as “authorized-force”: