TP-Link T2600G-28TS - Chapter 8 Ethernet OAM; 8.1 Basic Config; 8.2 Link Monitoring

116
16.3 ipv6 dhcp snooping vlan
Description
The ipv6 dhcp snooping vlan command is used to enable DHCPv6 Snooping
function on a specified VLAN. To disable DHCPv6 Snooping function on this
VLAN, please use no ipv6 dhcp snooping vlan command.
Syntax
ipv6 dhcp snooping vlan vlan-range
no ipv6 dhcp snooping vlan vlan-range
Parameter
vlan-range —— Specify the VLANs to enable the DHCPv6 snooping function, in
the format of 1-3, 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the DHCPv6 Snooping function on VLAN 1,4,6-7:
T2600G-28TS(config)#ipv6 dhcp snooping vlan 1,4,6-7
16.4 ipv6 dhcp snooping trust
Description
The ipv6 dhcp snooping trust command is used to configure a port to be a
Trusted Port. Only the Trusted Port can forward the DHCPv6 packets from
DHCPv6 servers. To turn the port back to a distrusted port, please use no ipv6
dhcp snooping trust command.
Syntax
ipv6 dhcp snooping trust
no ipv6 dhcp snooping trust