TP-Link T2600G-28TS - Range; Ip Igmp Filter

313
T2600G-28TS(config)# ip igmp profile 1
T2600G-28TS(config-igmp-profile)#permit
37.23 range
Description
The range command is used to configure the range of the profile’s filtering
multicast address. To delete the corresponding filtering multicast address,
please use no range command. A profile contains 16 filtering IP-range entries
at most.
Syntax
range start-ip end-ip
no range start-ip end-ip
Parameter
start-ip —— The start filtering multicast IP address.
end-ip —— The end filtering multicast IP address.
Command Mode
Profile Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure one of the filter multicast address entry as range 225.1.1.1 to
226.3.2.1 in profile 1:
T2600G-28TS(config)# ip igmp profile 1
T2600G-28TS(config-igmp-profile)#range 225.1.1.1 226.3.2.1
37.24 ip igmp filter
Description
The ip igmp filter command is used to bind the specified profile to the interface.
To delete the binding, please use no ip igmp filter command.
Syntax
ip igmp filter profile-id
no ip igmp filter