TP-Link T2600G-28TS - Ip Arp Inspection Recover; Show Ip Arp Inspection

131
19.5 ip arp inspection recover
Description
The ip arp inspection recover command is used to restore a port to the ARP
transmit status from the ARP filter status.
Syntax
ip arp inspection recover
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Restore Gigabit Ethernet port 1/0/5 to the ARP transmit status:
T2600G-28TS(config)#interface gigabitEthernet 1/0/5
T2600G-28TS(config-if)#ip arp inspection recover
19.6 show ip arp inspection
Description
The show ip arp inspection command is used to display the ARP detection
global configuration including the enable/disable status and the Trusted Port list.
Syntax
show ip arp inspection
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the ARP detection configuration globally:
T2600G-28TS(config)#show ip arp inspection