TP-Link T2600G-28TS - Show Ip Http Configuration

96
Parameter
ssl-key —— The name of the SSL key which is selected to download to the
switch. The length of the name ranges from 1 to 25 characters. The Key must
be BASE64 encoded.
ip-addr —— The IP address of the TFTP server. Both IPv4 and IPv6 addresses
are supported, for example 192.168.0.1 or fe80::1234.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Download an SSL key named ssl-key from TFTP server with the IP address of
192.168.0.146:
T2600G-28TS(config)# ip http secure-server download key ssl-key
ip-address 192.168.0.146
Download an SSL key named ssl-key from TFTP server with the IP address of
fe80::1234
T2600G-28TS(config)# ip http secure-server download key ssl-key
ip-address fe80::1234
13.11 show ip http configuration
Description
The show ip http configuration command is used to display the configuration
information of the HTTP server, including status, session timeout,
access-control, max-user number and the idle-timeout, etc.
Syntax
show ip http configuration
Command Mode
Privileged EXEC Mode and Any Configuration Mode