TP-Link T2600G-28TS - Ip Igmp Snooping Querier Vlan

307
please use no ip igmp snooping multi-vlan-config replace-sourceip
command.
Syntax
ip igmp snooping multi-vlan-config [ vlan-id ] replace-sourceip ip
no ip igmp snooping multi-vlan-config replace-sourceip
Parameter
vlan-id—— The ID of the multicast VLAN.
ip —— Specify the IP address. The switch will use this IP address to replace the
source IP address of the IGMP packets.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Replace the source IP address of the IGMP packets in multicast VLAN 1 as
192.168.0.112:
T2600G-28TS(config)# ip igmp snooping multi-vlan-config 1
replace-sourceip 192.168.0.112
37.15 ip igmp snooping querier vlan
Description
The ip igmp snooping querier vlan command is used to enable the IGMP
Snooping Querier function of the VLAN(s). To disable the IGMP Snooping
Querier function of certain VLANs, please use no ip igmp snooping querier
vlan command.
Syntax
ip igmp snooping querier vlan vlan-id
no ip igmp snooping querier vlan vlan-id
Parameter
vlan-id — VLAN ID, ranging from 1 to 4094.
Command Mode
Global Configuration Mode