TP-Link T2600G-28TS - 13.5 ARP Inspection

256
33.18 qos-remark
Description
The qos-remark command is used to configure QoS Remark function of policy
action.
Syntax
qos-remark [ dscp dscp ] [ priority pri ]
no qos-remark
Parameter
dscp —— DSCP of QoS Remark. Specify the DSCP region for the data packets
matching the corresponding ACL. DSCP ranges from 0 to 63. By default, it is not
limited.
pri —— Local Priority of QoS Remark. Specify the local priority for the data
packets matching the corresponding ACL. Local Priority ranges from 0 to 7.
Command Mode
Action Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Edit the actions for policy1. For the data packets matching ACL 120, specify the
DSCP region as 30 and local priority 2:
T2600G-28TS(config)#access-list policy action policy1 120
T2600G-28TS(config-action)# qos-remark dscp 30 priority 2
33.19 access-list bind acl(interface)
Description
The access-list bind acl command is used to bind an ACL to the specified port.
To cancel the bind relation, please use no access-list bind acl command.
Syntax
access-list bind acl acl-id
no access-list bind acl acl-id
Parameter
acl-id —— The ID of the ACL desired to bind.