34
3.12 show interface switchport
Description
The show interface switchport command is used to display the IEEE 802.1Q
VLAN configuration information of the specified port/port channel.
Syntax
show interface switchport [ gigabitEthernet port | port-channel
port-channel-id ]
Parameter
port —— The port number.
port-channel-id —— The ID of the port channel.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the VLAN configuration information of all ports and port channels:
T2600G-28TS(config)# show interface switchport
To Next Page
Loading...
