TP-Link T2600G-28TS - Ip Dhcp Snooping Limit Rate; Ip Dhcp Snooping Decline Rate

109
T2600G-28TS(config)#interface gigabitEthernet 1/0/2
T2600G-28TS(config-if)#ip dhcp snooping mac-verify
15.10 ip dhcp snooping limit rate
Description
The ip dhcp snooping limit rate command is used to enable the Flow Control
feature for the DHCP packets. The excessive DHCP packets will be discarded.
To restore to the default configuration, please use no ip dhcp snooping limit
rate command.
Syntax
ip dhcp snooping limit rate value
no ip dhcp snooping limit rate
Parameter
value —— The value of Flow Control. The options are 5/10/15/20/25/30
(packet/second). The default value is 0, which stands for “disable”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Set the Flow Control of GigabitEthernet port 2 as 20 pps:
T2600G-28TS(config)#interface gigabitEthernet 1/0/2
T2600G-28TS(config-if)#ip dhcp snooping limit rate 20
15.11 ip dhcp snooping decline rate
Description
The ip dhcp snooping decline rate command is used to enable the Decline
Protect feature and configure the rate limit on DHCP Decine packets. The
excessive DHCP Decline packets will be discarded. To disable the Decline
Protect feature, please use no ip dhcp snooping decline rate command.