TP-Link T2600G-28TS - Sflow Enable; Sflow Collector Collector-ID

373
41.2 sflow enable
Description
The sflow enable command is used to enable sFlow function. To disable the
sFlow function, please use no sflow enable command.
Syntax
sflow enable
no sflow enable
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
User Guidelines
A valid agent address should be assigned to the sFlow agent embedded in the
switch before you enable the sFlow function.
Example
Enable sFlow function globally:
T2600G-28TS(config)#sflow enable
41.3 sflow collector collector-ID
Description
The sflow collector collector-ID command is used to configure the parameters
about the sFlow collector.
Syntax
sflow collector collector-ID value { [descript descript ] | [ ip ip ] | [ port port ] |
[ maxData maxData ] | [ timeout timeout ] }
Parameter
value —— The ID of the sFlow collector you desire to configure. The value
ranges from 1 to 4.
descript ——Give a description to the sFlow collector, which contains 16
characters at most.
ip ——The IP address of the sFlow collector. The type of the IP address should
be IPv4, for example 192.168.0.100.
port ——The number of the udp port which is selected for the sFlow collector.