TP-Link T2600G-28TS - Ethernet-Oam Link-Monitor Symbol-Period

281
Syntax
ethernet-oam mode { passive | active }
no ethernet-oam mode
Parameter
passive —— Specify the OAM mode as passive.
active ——Specify the OAM mode as active.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure Ethernet OAM client to operate in passive mode for Gigabit Ethernet
port 2:
T2600G-28TS(config)# interface gigabitEthernet 1/0/2
T2600G-28TS(config-if)#ethernet-oam mode passive
35.3 ethernet-oam link-monitor symbol-period
Description
The ethernet-oam link-monitor symbol-period command is used to configure
the parameters about one of the link events, error symbol period event. To
return to the default configurations, please use no ethernet-oam link-monitor
symbol-period command.
Syntax
ethernet-oam link-monitor symbol-period { threshold threshold | window
window | notify { disable | enable }}
no ethernet-oam link-monitor symbol-period { threshold | window | notify }
Parameter
threshold —— Configure the error threshold for generating error symbol-period
event. The range is from 1 to 4294967295 and the default value is 1.