TP-Link T2600G-28TS - Clear Arp-Cache; Arp Timeout

99
14.2 clear arp-cache
Description
This clear arp-cache command is used to clear all the dynamic ARP entries.
Syntax
clear arp-cache
Command Mode
Privileged EXEC Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Clear all the dynamic ARP entries:
T2600G-28TS(config)# clear arp-cache
14.3 arp timeout
Description
This arp timeout command is used to configure the ARP aging time of the
interface.
Syntax
arp timeout timeout
no arp timeout
Parameter
timeout —— Specify the aging time, ranging from 1 to 3000 seconds. The
default value is 600 seconds.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.