TP-Link T2600G-28TS - Dot1 X Handshake; Dot1 X Auth-Method

138
21.2 dot1x handshake
Description
The dot1x handshake command is used enable the handshake feature. The
handshake feature is used to detect the connection status between the TP-LINK
802.1x supplicant and the switch. Please disable the handshake feature if you
are using a non-TP-LINK 802.1x-compliant client software. This feature is
enabled by default.
Syntax
dot1x handshake
no dot1x handshake
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Disable the 802.1X handshake function:
T2600G-28TS(config)# no dot1x handshake
21.3 dot1x auth-method
Description
The dot1x auth-method command is used to configure the Authentication
Method of IEEE 802.1X and the default 802.1x authentication method is “eap”.
To restore to the default 802.1x authentication method, please use no dot1x
auth-method command.
Syntax
dot1x auth-method { pap | eap }
no dot1x auth-method
Parameter
pap | eap ——Authentication Methods.