TP-Link T2600G-28TS - Range; Ipv6 Mld Filter

334
Example
Configure the filtering mode of profile 1 as permit:
T2600G-28TS(config)# ipv6 mld profile 1
T2600G-28TS(config-igmp-profile)#permit
38.21 range
Description
The range command is used to configure the range of the profile’s filtering
multicast address. To delete the corresponding filtering multicast address,
please use no range command. A profile contains 16 filtering IP-range entries
at most.
Syntax
range start-ip end-ip
no range start-ip end-ip
Parameter
start-ip —— Start IPv6 multicast address of the filter entry..
end-ip —— End IPv6 multicast address of the filter entry.
Command Mode
Profile Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure one of the filter multicast address entry as range ff80::1234 to
ff80::1235 in profile 1:
T2600G-28TS(config)# ipv6 mld profile 1
T2600G-28TS(config-igmp-profile)#range ff80::1234 ff80::1235
38.22 ipv6 mld filter
Description
The ipv6 mld filter command is used to bind the specified profile to the
interface. To delete the binding, please use no ipv6 mld filter command.
Syntax
ipv6 mld filter profile-id