TP-Link T2600G-28TS - Show Qos Interface; Show Qos Cos-Map

228
29.7 show qos interface
Description
The show qos interface command is used to display the configuration of QoS
based on port priority.
Syntax
show qos interface [ gigabitEthernet port-list ] [ port-channel lagid-list ]
Parameter
port-list ——The list of Ethernet ports.
lagid-list —— The list of LAGs.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the configuration of QoS for all ports and LAGs:
T2600G-28TS# show qos interface
Display the configuration of QoS for ports 1/0/1-4:
T2600G-28TS# show qos interface gigabitEthernet 1/0/1-4
29.8 show qos cos-map
Description
The show qos cos-map command is used to display the configuration of IEEE
802.1P Priority and the mapping relation between cos-id and tc-id.
Syntax
show qos cos-map
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the configuration of IEEE 802.1P Priority and the mapping relation
between cos-id and tc-id: