TP-Link T2600G-28TS - 13.11 AAA

277
34.24 show spanning-tree bridge
Description
The show spanning-tree bridge command is used to display the bridge
parameters.
Syntax
show spanning-tree bridge [ forward-time | hello-time | hold-count | max-age |
max-hops | mode | priority | state ]
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the bridge parameters:
T2600G-28TS(config)# show spanning-tree bridge
34.25 show spanning-tree interface
Description
The show spanning-tree interface command is used to display the
spanning-tree information of all ports or a specified port.
Syntax
show spanning-tree interface [ gigabitEthernet port | port-channel
port-channel-id ] [ edge | ext-cost | int-cost | mode | p2p | priority | role | state |
status ]
Parameter
port —— The Ethernet port number.
port-channel-id —— The ID of the port channel.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the spanning-tree information of all ports: