TP-Link T2600G-28TS - Show Interface Vlan; Show Ip Interface

383
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Create a static route with the destination network IP address as 3200::/64 and
the next-hop address as 3100::1234:
T2600G-28TS(config)# ipv6 route 3200::/64 3100::1234
42.11 show interface vlan
Description
The show interface vlan command is used to display the information of the
specified interface VLAN.
Syntax
show interface vlan vid
Parameter
vid —— The VLAN ID.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the information of VLAN 2:
T2600G-28TS(config)#show interface vlan 2
42.12 show ip interface
Description
This show ip interface command is used to display the detailed information of
the specified Layer 3 interface.