TP-Link T2600G-28TS - Show Tacacs-Server; Radius-Server Host

393
Example
Configure a TACACS+ server with the IP address as 1.1.1.1, TCP port as 1500,
timeout as 6 seconds, and the unencrypted key string as 12345.
T2600G-28TS(config)# tacacs-server host 1.1.1.1 port 1500 timeout 6 key
12345
44.3 show tacacs-server
Description
This show ip tacacs-server command is used to display the summary
information of the TACACS+ servers.
Syntax
show tacacs-server
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Display the information of all the TACACS+ servers:
T2600G-28TS(config)# show tacacs-server
44.4 radius-server host
Description
The radius-server host command is used to configure a new RADIUS server.
To delete the specified RADIUS server, please use no radius-server host
command.
Syntax
radius-server host ip-address [ auth-port port-id ] [ acct-port port-id ]
[ timeout time ] [ retransmit number ] [ key { [ 0 ] string | 7 encrypted-string } ]
no radius-server host ip-address
Parameter
ip-address —— Specify the IP address of the RADIUS server.