TP-Link T2600G-28TS - Enable Authentication(Telnet); Enable Authentication(Ssh)

406
Example
Configure the login authentication method list on the ssh terminal line as “list1”:
T2600G-28TS(config)# line ssh
T2600G-28TS(config-line)# login authentication list1
44.22 enable authentication(telnet)
Description
The enable authentication command is used to apply the privilege
authentication method list to the telnet terminal line. To restore to the default
authentication method list, please use the no enable authentication command.
Syntax
enable authentication { method-list }
no enable authentication
Parameter
method-list —— Specify the enable method list on the telnet terminal line. It is
“default” by default, which contains the method “none”.
Command Mode
Line Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Configure the enable authentication method list on the telnet terminal line as
“list2”:
T2600G-28TS(config)#line telnet
T2600G-28TS(config-line)# enable authentication list2
44.23 enable authentication(ssh)
Description
The enable authentication command is used to apply the privilege
authentication method list to the ssh terminal line. To restore to the default
authentication method list, please use the no enable authentication command.