TP-Link T2600G-28TS - Show Gvrp Interface; Show Gvrp Global

61
Example
Set the GARP leaveall timer of Gigabit Ethernet port 1/0/6 as 2000 centiseconds
and restore the join timer of it to the default value:
T2600G-28TS(config)#interface gigabitEthernet 1/0/6
T2600G-28TS(config-if)#gvrp timer leaveall 2000
T2600G-28TS(config-if)#no gvrp timer join
9.5 show gvrp interface
Description
The show gvrp interface command is used to display the GVRP configuration
information of a specified Ethernet port or of all Ethernet ports.
Syntax
show gvrp interface [ gigabitEthernet port | port-channel port-channel-id ]
Parameter
port —— The port number.
port-channel-id —— The ID of the port channel.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the GVRP configuration information of Gigabit Ethernet port 1:
T2600G-28TS(config)#show gvrp interface gigabitEthernet 1/0/1
Display the GVRP configuration information of all Ethernet ports:
T2600G-28TS(config)#show gvrp interface
9.6 show gvrp global
Description
The show gvrp global command is used to display the global GVRP status.