TP-Link T2600G-28TS - 15.3 Device Statistics

299
37.4 ip igmp snooping mtime
Description
The ip igmp snooping mtime command is used to specify member port aging
time globally. The default aging time is 260 seconds. To restore the default timer,
please use no ip igmp snooping mtime command.
Syntax
ip igmp snooping mtime mtime
no ip igmp snooping mtime
Parameter
mtime —— Specify the aging time in seconds, ranging from 60 to 600. The
default aging time is 260 seconds.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify IGMP Snooping member port aging time as 100 seconds globally:
T2600G-28TS(config)# ip igmp snooping mtime 100
37.5 ip igmp snooping report-suppression
Description
The ip igmp snooping report-suppression command is used enable the
IGMP report suppression function. When it is enabled, the switch forwards only
the first IGMP report message per mulicast group to the Layer 3 device, and the
subsequent IGMP reports from the same multicast group are discarded. To
disable the IGMP report suppression function and forward all the IGMP reports
to the Layer 3 device, please use no ip igmp snooping report-suppression
command. This function is disabled by default.
Syntax
ip igmp snooping report-suppression
no ip igmp snooping report-suppression
Command Mode
Global Configuration Mode