TP-Link T2600G-28TS - 8.4 Remote Loopback

118
16.6 ipv6 nd snooping vlan
Description
The ipv6 nd snooping vlan command is used to enable ND Snooping function
on a specified VLAN. To disable ND Snooping function on this VLAN, please
use no ipv6 nd snooping vlan command.
Syntax
ipv6 nd snooping vlan vlan-range
no ipv6 nd snooping vlan vlan-range
Parameter
vlan-range —— Specify the VLANs to enable the ND snooping function, in the
format of 1-3, 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the ND Snooping function on VLAN 1,4,6-7:
T2600G-28TS(config)#ipv6 nd snooping vlan 1,4,6-7
16.7 ipv6 nd snooping max-entries
Description
The ipv6 nd snooping max-entries command is used to specify the maximum
number of binding entries that are allow to be binded to a port. To return the
default, please use no ipv6 nd snooping max-entries command.
Syntax
ipv6 nd snooping max-entries value
no ipv6 nd snooping max-entries
Parameter
value —— Specify the maximum number of ND snooping entries on this
interface.