TP-Link T2600G-28TS - Show Dldp Interface

296
36.8 show dldp interface
Description
The show dldp interface command is used to display the configuration and
state of the specified Ethernet port. By default, the configuration and state of all
the ports will be displayed.
Syntax
show dldp interface [gigabitEthernet port ]
Parameter
port —— The Gigabit Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the configuration and state of all ports:
T2600G-28TS# show dldp interface
Display the configuration and state of port 1/0/5:
T2600G-28TS# show dldp interface gigabitEthernet 1/0/5