TP-Link T2600G-28TS - Show Etherchannel

72
Parameter
pri —— The port priority, ranging from 0 to 65535. It is 32768 by default.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the LACP port priority as 1024 for ports 1-3:
T2600G-28TS(config)# interface range gigabitEthernet 1/0/1-3
T2600G-28TS(config-if-range)# lacp port-priority 1024
Configure the LACP port priority as 2048 for port 4:
T2600G-28TS(config)# interface gigabitEthernet 1/0/4
T2600G-28TS(config-if)# lacp port-priority 2048
11.5 show etherchannel
Description
The show etherchannel command is used to display the EtherChannel
information.
Syntax
show etherchannel [ channel-group-num ] { detail | summary }
Parameter
channel-group-num —— The EtherChannel Group number, ranging from 1 to
14. By default, it is empty, and will display the information of all EtherChannel
Groups.
detail —— The detailed information of EtherChannel.
summary —— The EtherChannel information in summary.
Command Mode
Privileged EXEC Mode and Any Configuration Mode