TP-Link T2600G-28TS - Chapter 43 SDM Template Commands; Sdm Prefer

389
Chapter 43 SDM Template Commands
This chapter describes how to configure the Switch Database Management (SDM) templates to
allocate hardware resources on the switch for different uses.
43.1 sdm prefer
Description
The sdm prefer command is used to configure the SDM template. The SDM
template is used to allocate system resources to best support the features being
used in your application. To return to use the default template, please use the
sdm prefer default command. The template change will takes effect after a
reboot.
Syntax
sdm prefer { default | enterpriseV4 | enterpriseV6 }
Parameter
default —— Specify the SDM template used in the switch as “default”.
enterpriseV4 —— Specify the SDM template used in the switch as
“enterpriseV4”.
enterpriseV6 —— Specify the SDM template used in the switch as
“enterpriseV6”.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Specify the SDM template as enterpriseV4:
T2600G-28TS(config)# sdm prefer enterpriseV4