TP-Link T2600G-28TS - Telnet; Serial_Port Baud-Rate

85
12.12 telnet
Description
The telnet enable command is used to enable the Telnet function. To disable
the Telnet function, please use the telnet disable command. This function is
enabled by default.
Syntax
telnet enable
telnet disable
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Disable the Telnet function:
T2600G-28TS(config)# telnet disable
12.13 serial_port baud-rate
Description
The serial_port baud-rate command is used to configure the communication
baud rate on the console port. To return to the default baud rate, please use no
serial_port command.
Syntax
serial_port baud-rate { 9600 | 19200 | 38400 | 57600 | 115200 }
no serial_port
Parameter
9600 | 19200 | 38400 | 57600 | 115200 ——Specify the communication baud
rate on the console port. The default baul rate is 38400 bps.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.