TP-Link T2600G-28TS - Chapter 12 ACL; 12.1 Time-Range

218
Parameter
port —— The Ethernet port number.
port-channel-id
—— The ID of the port channel.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Clear the statistic information of all ports and port channels:
T2600G-28TS(config)# clear counters
28.13 show interface status
Description
The show interface status command is used to display the connection status
of the Ethernet port/port channel.
Syntax
show interface status [ gigabitEthernet port ] [ port-channel port-channel-id ]
Parameter
port —— The Ethernet port number.
port-channel-id
—— The ID of the port channel..
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the connection status of all ports and port channels:
T2600G-28TS(config)# show interface status
Display the connection status of port 1/0/1:
T2600G-28TS(config)# show interface status gigabitEthernet 1/0/1
28.14 show interface counters