TP-Link T2600G-28TS - Show Storm-Control; Show Bandwidth

220
Example
Display the configurations of all Ethernet ports and port channels:
T2600G-28TS(config)# show interface configuration
Display the configurations of port 1/0/2:
T2600G-28TS(config)# show interface configuration gigabitEthernet 1/0/2
28.16 show storm-control
Description
The show storm-control command is used to display the storm-control
information of Ethernet ports.
Syntax
show storm-control interface [ gigabitEthernet port-list ] [ port-channel
port-channel-id-list ]
Parameter
port-list ——The list of Ethernet ports.
port-channel-id-list —— The list of port channels.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the storm-control information of port 4, 5, 6, and 7:
T2600G-28TS(config)# show storm-control interface gigabitEthernet
1/0/4-7
28.17 show bandwidth
Description
The show bandwidth command is used to display the bandwidth-limit
information of Ethernet ports.
Syntax
show bandwidth interface [ gigabitEthernet port-list ] [ port-channel
port-channel-id-list ]