TP-Link T2600G-28TS - Ip Igmp Snooping Max-Groups

309
T2600G-28TS(config)#ip igmp snooping querier vlan 2 query-interval 200
T2600G-28TS(config)#ip igmp snooping querier vlan 2 max-response-time
20
37.17 ip igmp snooping max-groups
Description
The ip igmp snooping max-groups command is used to configure the
maximum number of groups that a port can join in. The ip igmp snooping
max-groups action is used to configure the action that the port takes when it
receives an IGMP report message and the maximum number of entries is in the
forwarding table. To remove the maximum group limitation and return to the
default of no limitation on the specified port, please use the no ip igmp
snooping max-groups command. To return to the default action of dropping
the report, please use the no ip igmp snooping max-groups action command.
These commands only apply to the dynamic multicast groups.
Syntax
ip igmp snooping max-groups [ maxgroup ]
ip igmp snooping max-groups action { drop | replace }
no ip igmp snooping max-groups
no ip igmp snooping max-groups action
Parameter
maxgroup —— Specify the maximum numbers of groups that the port can join.
It ranges from 0 to 1000 and the default value is 1000.
drop —— When the number of the dynamic multicast groups that a port joins
has exceeded the max-group, the port will not join any new multicast group.
replace —— When the number of the dynamic multicast groups that a port joins
has exceeded the max-group, the newly joined multicast group will replace an
existing multicast group with the lowest multicast group address.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.