TP-Link T2600G-28TS - Ip Igmp Snooping Authentication

310
Example
Specify the maximum numbers of groups that ports 1/0/2-5 can join as 10, and
configure the throttling action as replace:
T2600G-28TS(config)#interface range gigabitEthernet 1/0/2-5
T2600G-28TS(config-if-range)#ip igmp snooping max-groups 10
T2600G-28TS(config-if-range)#ip igmp snooping max-groups action
replace
37.18 ip igmp snooping authentication
Description
The ip igmp snooping authenticaiton command is used to authenticate the
users who want to join the limited multicast source. To disable the multicast
authentication, please use no ip igmp snooping authentication command.
Syntax
ip igmp snooping authentication
no ip igmp snooping authentication
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
User Guidelines
The IGMP Authentication feature will take effect only when AAA function is
enabled and the RADIUS server is configured. For how to enable AAA function
and configure RADIUS server, please refer to aaa enable and radius-server
host.
Example
Enable IGMP authentication on port 1/0/3:
T2600G-28TS(config)# interface gigabitEthernet 1/0/3
T2600G-28TS(config-if)# ip igmp snooping authentication