4-24
IM DL950-02EN
Setting the Trigger Conditions (Pattern Setup)
2.
Tap Pattern Setup, or press the soft key. The following menu appears.
Set the synchronization channel
(Auto, CH1 to CH16).
Set the source channel (ON, OFF).
Set the tolerance width.
Set the hysteresis ( , , ).*
Set the cycle frequency.
Set the reference cycle.
* Not required when the synchronization channel is Auto
Set the level for detecting the
start and end points.*+
4.14 Triggering on a Wave Window Trigger (Enhanced)
To Next Page
Loading...
